- This flap hinge is made of zinc die cast and is designed to be used in conjunction with a lid support as the hinge is free swinging.
- Designed to be used with 5/8" thick material.
- Three way adjustability: 1/8" side-to-side, 1/8" back-to-back and 1/16" up and down.
- Installation requires a 1-3/8" (35mm) diameter hole, 15/32" (12mm) deep and centered 11/32" from edge of two surface opening angle is 90 degrees.
- Packing: As shown below without screws. Sold In: Both broken and full box quantities. Discount available for full box orders.
| Color/Finish |
Chrome |
| Length |
2-1/4 in |
| Motion Technology |
Free Swinging |
| Mount Type |
Screw-On |
| Width |
1-1/2 in |
